Brown University chemists for the first time have consistently created uniform platinum nanocubes, a breakthrough that could make hydrogen fuel cells cheaper and more efficient.

PROVIDENCE, R.I. [Brown University] — Two great obstacles to hydrogen-powered vehicles lie with fuel cells. Fuel cells, which like batteries produce electrical power through chemical reactions, have been plagued by their relatively low efficiency and high production costs. Scientists have tested a wide assortment of metals and materials to overcome the twin challenge.

Now a team led by Shouheng Sun, professor of chemistry at Brown, has mastered a Rubik’s Cube-like dilemma for dealing with platinum, a precious metal coveted for its ability to boost a chemical reaction in fuel cells. The team shows that shaping platinum into a cube greatly enhances its efficiency in a phase of the fuel cell’s operation known as oxygen reduction reaction. Sun’s results have been published online in the journal Angewandte Chemie (pdf). The paper was selected as a Very Important Paper, a distinction reserved for less than 5 percent of manuscripts submitted to the peer-reviewed journal.

Making a Platinum Nanocube
Transmission electron microscopy, far left, shows 7-nm. platinum nanocubes used for oxygen reduction reaction. In the upper right corner is a high-resolution picture of a single nanocube. The illustration depicts oxygen reduction on the surface of a nanocube.
Image:
Chao Wang/Brown University

Platinum helps reduce the energy barrier – the amount of energy needed to start a reaction – in the oxidation phase of a fuel cell. It is also seen as beneficial on the other end of the fuel cell, known as the cathode. There, platinum has been shown to assist in oxygen reduction, a process in which electrons peeled from hydrogen atoms join with oxygen atoms to create electrical energy. The reaction also is important because it only produces water. This byproduct – rather than the global warming gas carbon dioxide – is a big reason why hydrogen fuel cells are a tantalizing area of research from automakers in Detroit to policy-makers in Washington.

Scientists, however, have had trouble maximizing platinum’s potential in the oxygen reduction reaction. The barriers chiefly revolve around shape and surface area – geometry and geography, so to speak. What Sun has learned is that molding platinum into a cube on the nanoscale enhances its catalysis – that is, it boosts the rate of a chemical reaction.

“For the first time, we can control the morphology of the particle to make it more like a cube,” Sun said. “People have had very limited control over this process before. Now we have shown it can be done uniformly and consistently.”

During his experiments, Sun, along with Brown graduate engineering student Chao Wang and engineers from the Japanese firm Hitachi Maxwell Ltd., created polyhedron and cube shapes of different sizes by adding platinum acetylacetonate (Pt(acac)₂) and a trace amount of iron pentacarbonyl (Fe(CO)₅) at specific temperature ranges. The team found that cubes were more efficient catalysts, owing largely to their surface structure and their resistance to being absorbed by the sulfate in the fuel cell solution.

“For this reaction, the shape is more important than the size,” Sun said.

The next step, Sun added, is to build a polymer electrolyte membrane fuel cell and test the platinum nanocubes as catalysts in it. The team expects the experiments will yield fuel cells with a higher electrical output than previous versions.

“It’s like science fiction, but we’re a step closer now to the reality of developing a very efficient platinum catalyst for hydrogen cars that produce only water as exhaust,” Sun said.

Hitachi Maxell chemical engineers Hideo Daimon, Taigo Ondera and Tetsunori Koda, a visiting engineer at Brown, contributed to the research.

The research was funded by the National Science Foundation and by the Office of the Vice President for Research at Brown University through its Research Seed Fund.

Editors: Brown University has a fiber link television studio available for domestic and international live and taped interviews and maintains an ISDN line for radio interviews. For more information, call the Office of Media Relations at (401) 863-2476.

######